PocketWizard N90M3 Motor Cord, Nikon 10 Pin to Mini – 3′

This cable connects your radio to your cameras remote shutter release terminal to enable remote camera triggering.This standard cable works with most PocketWizard radios but has no half-press control, and is for basic remote triggering only.

AN90M3P (PreTrigger) cable works with most PocketWizard radios. This pre-trigger cable has a switch that allows you to toggle half-press on or off at the camera position, but not remotely. AN10-ACC or N10-ACC-200cable allows a compatible PocketWizard radio to independently control both half-press and full-press functions, as well as relay E-TTL signals to compatible flashes when using FlexTT5s.

Standard Remote Cable for connecting a Plus II or MultiMAX with no ACC port to a Nikon 10-pin remote terminal.

Cable length: 3′ (91.5 cm)

From: 1/8″ (3.5 mm) mono miniphone
To:Nikon 10-pin remote shutter release terminal

Compatible with the following radios:

• Plus II:Use this cable to remotely fire your camera.
• Plus III:This cable can remotely fire your camera but it has no half-press control.Use aN10ACC or N10-ACC-D200cable for best results.
• FlexTT5: This cable can be used to remotely fire your camera, like a N90M3P cable with a FlexTT5, but your remote camera will not be able to relay an E-TTL signal to Speedlites.Use a N10ACC or N10-ACC-D200 cable for best results.Learn more here.
• MultiMAX with no ACC port: Use this cable to remotely fire your camera.
• MultiMAX with ACC port: This cable can remotely fire your camera but it has no half-press control.Use a N10ACCorN10-ACC-D200cable for best results.

Please see this PocketWizard Wikifor more details.

Compatible with cameras using Nikon’s 10-pin remote shutter release terminal.